1 Hour Concrete and Masonry Construction - Online

Frequently Asked Questions

What is the 1-Hour Concrete and Masonry Construction course?

It is an online safety-awareness course addressing common concrete and masonry hazards, formwork, reinforcing steel, material handling, silica dust, personal protective equipment, and reporting.

How long is the course?

The listed course duration is one hour.

What is the course code?

The course code shown on the page is CM1.

Is this course offered online?

Yes. The page identifies it as online. Confirm current device, identity-verification, attendance, and completion requirements before registering.

How much does the course cost?

The page currently lists a total cost of $399. Confirm current pricing, schedule, availability, inclusions, and refund terms directly with IDI.

What hazards are addressed?

Topics include falls, struck-by and caught-between hazards, formwork and shoring failure, impalement, material handling, concrete burns, silica dust, equipment movement, and unstable masonry walls.

Does the course reference OSHA requirements?

The page references OSHA 29 CFR 1926 Subpart Q for concrete and masonry construction. Other requirements may also apply, including fall protection, silica, PPE, scaffolds, cranes, electrical safety, and hazard communication.

Does this course provide SST credit?

The page states that the course counts as one hour of Specialized Elective credit toward an SST card and is valid for five years unless NYC Department of Buildings specifies otherwise. Confirm current DOB acceptance, eligibility, provider status, and card requirements before enrolling.

Who may design or approve formwork and shoring?

Formwork, shoring, reshoring, bracing, and removal must follow applicable plans, engineering requirements, manufacturer instructions, concrete-strength information, and competent or qualified-person oversight as required.

When can forms or shores be removed?

Removal should occur only when authorized under the project design and procedures and when the concrete has sufficient strength for the loads involved. A general awareness course does not make that determination.

How should exposed reinforcing steel be controlled?

Use required guarding, caps, troughs, covers, barricades, or other controls appropriate to the hazard. Not every cap is designed to protect against impalement, so follow approved site requirements.

What controls are used for silica dust?

Use the employer exposure-control plan and applicable OSHA silica requirements, including specified engineering controls, work practices, housekeeping methods, respiratory protection, training, and medical surveillance when required.

What PPE may be required?

Depending on the assessment, PPE may include eye or face protection, gloves resistant to wet concrete, protective clothing, safety footwear, hearing protection, high-visibility apparel, head protection, or respiratory protection.

What precautions apply to masonry walls?

Follow the limited-access-zone, bracing, stability, sequencing, lifting, and competent-person requirements applicable to the wall and construction stage. Keep unauthorized workers outside controlled areas.

Does course completion authorize concrete or masonry operations?

No. Completion does not replace job-specific training, employer authorization, competent supervision, engineering controls, equipment qualification, or trade and licensing requirements.

How can I confirm the class schedule?

Review the schedule table on the page and contact IDI to verify that the desired session is currently available.