1 Hour Tools - Hand and Power - Online

Frequently Asked Questions

What is the 1-Hour Tools - Hand and Power course?

It is an online safety-awareness course covering hazards and safer practices associated with common hand and power tools used in construction and trade work.

How long is the course?

The listed course duration is one hour.

What is the course code?

The course code shown on the page is TP1.

Is the course online?

Yes. The page identifies this course as online. Confirm current access, identity-verification, device, attendance, and completion requirements before registering.

How much does the course cost?

The page currently lists a total cost of $399. Confirm the current price, inclusions, refund terms, and availability directly with IDI before enrollment.

What topics are covered?

Topics include tool selection, pre-use inspection, guarding, personal protective equipment, safe operation, electrical and pneumatic hazards, housekeeping, storage, and manufacturer instructions.

Does the course discuss OSHA requirements?

The course page references OSHA construction requirements, including 29 CFR 1926 Subpart I. Training does not replace an employer hazard assessment, competent supervision, manufacturer instructions, or task-specific procedures.

Does this course provide SST credit?

The page states that the course counts as one hour of General Elective credit toward an SST card and is valid for five years unless NYC Department of Buildings specifies otherwise. Confirm current DOB acceptance, eligibility, provider status, and card requirements before enrolling.

What should be checked before using a tool?

Inspect the tool, cord, plug, battery, hose, guard, handle, accessory, switch, and other safety features; verify the tool is suitable for the task and remove damaged equipment from service under workplace procedures.

Can a guard or safety device be removed?

No. Required guards and safety devices should remain installed, functional, and properly adjusted. Follow the manufacturer instructions and employer procedures.

What PPE may be needed?

PPE depends on the tool and hazard assessment and may include eye or face protection, hearing protection, gloves appropriate to the task, safety footwear, respiratory protection, or other equipment. PPE does not replace engineering or administrative controls.

What are common power-tool hazards?

Hazards can include contact with moving parts, flying material, kickback, electric shock, noise, vibration, dust, sparks, fire, entanglement, and unexpected startup.

Should power be disconnected before adjustments?

Follow lockout or energy-control procedures and manufacturer instructions. Disconnect or otherwise isolate the energy source before changing accessories, clearing jams, servicing, or making adjustments when required.

Can workers use damaged tools?

Damaged, modified, or malfunctioning tools should be tagged or otherwise removed from service and reported according to employer procedures. Repairs should be performed only by authorized qualified personnel.

Does completing the class authorize someone to operate every tool?

No. Course completion does not by itself establish task-specific competency or authorization. Employers must provide the training, supervision, equipment, and authorization required for the actual tool and work conditions.

How can I confirm the schedule?

Use the schedule table on the page and contact IDI to confirm that the desired date and session are currently available.